Rima Heating Systems ON Series Instructions d'exploitation

S.MAX SERIES SOLID FUEL BOILERS.MAX SERIES SOLID FUEL BOILER0-S.MAXREV.01 / 201000360036

Changing the hatch position controls the combustion intensity and thus the boiler output. The thermo mecha-nical output regulator is connected with th

Temperature safety valveThe S.MAX boilers are equipped with a safety valve (Fig.10) which ensures dissipation of excessive heat withoutadditional de

Hydraulic Connection DiagramIt is suggested that open type hydraulic system should be installed according to following schemes. fig.111. Safety H

Putting the boiler into service Before putting the boiler into operation the service technician must check:Checking the boiler before turning it on

Provide an even layer throughout the entire boiler depth. If the fuel suddenly turns into dark red blaze, openpartially the secondary air supply ro

Dewing and tarringWhen starting fire in a cold boiler, water condensates on the walls and runs down into the ash compartment,which may make an imp

Periodic Controls :For efficient use, preventing the possible failures and optimum life of the boiler periodic controls are important.It isrecommended

fig.12 fig.13

Boiler repairsThe boiler may be repaired by an authorized service technician or organisation only. The user or ownermay do only normal mainten

Please note System must be connected to open expansion tank for safety reasons.Any valve must not be connected to safety input and safety output lin

IndexInformation on the boiler plate 2Boiler dimensions , Boiler packaging dimensions 3Technical parameters 4It d ti5Introduction 5Ensuring safety of

Minumum Distances

• Do not touch hot water connections or the flue outlet when the boiler is operating. Installation procedure•Place the boile

SMAX boiler partsfi 18 fig.18 fig.1921

Spare parts listpp fig.2022

Accumulator tank capacityNOTE : The heat can be supplied for example by an accumulator tank. The following applies as a reference for

Flue Pipe InstallationFig. 22 shows the proper flue gas connection with additional air equipment. Observe the following during the installation of t

The figures in Tab. (Fig. 22) are only guide figures. The draft depends on the diameter, height, roughness of the chimney wall, and the tem

Address: Ikitelli Organize Sanayi Bolgesi, Ataturk Bulvari, 17. Cad. No: 5 ISTANBUL - TURKEY Phone:+90 212 485 48 74 - Fax : +90 212 485 4

Information on the boiler plateThe boiler Serial No. is shown on the plate which is attached to the cover panel of the cast iron body.2

Boiler dimensionsBoiler packaging dimensions

Technical parameters4

Introduction1.The boiler and all associated equipment must be installed and used in accordance with the installation design, all applicable legal re

•Applicable regulations and standards ;•Sound installation and operation procedures•Conditions stated in the Warranty Certificate and the Service Book

Operating Instructions S.MAX Series Boiler – General features•S.MAX series solid fuel fired boiler is designed for heating both residential and

Control and safety devicesS.MAX boilers are equipped with three main control elements:A chimney flap ( Fig. 5 ), by means of which the chimney thr